Joel-L Posted November 19, 2018 Share Posted November 19, 2018 Hi All, I have a custom light, a Anolis ArcPar, which has a 7 Degree beam angle. When I import the IES file into the distribution load section for the custom light, the custom light doesn't have a 7 degree beam angle. The beam angle produced is greater than 7 degrees, even with spill. This is the product: https://www.anolislighting.com/products/arcpartm-100 This is the first time that I am using custom lights so I might be doing something wrong but didn't think I was. Any help would be greatly appreciated. Joel Quote Link to comment
BSeigel Posted November 21, 2018 Share Posted November 21, 2018 Just finished testing, the IES profile has a huge spread and is very bright. (Even for a 200W LED) Dimming it produced more reasonable results. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.