Charlie Winter Posted November 15, 2018 Share Posted November 15, 2018 I seem to have toggled a setting in my drawing, where the floating data bar only shows a field, "distance", rather than the intended xyz, length etc... Distance only... Standard Data Bar How do I get that back without starting a new drawing?? Thanks. Quote Link to comment
HEengineering Posted November 19, 2018 Share Posted November 19, 2018 When the line command has be started and you have clicked on your first point for starting the line,, you can hit tab and it will cycle over to x and Y coordinates. Quote Link to comment
HEengineering Posted November 19, 2018 Share Posted November 19, 2018 Also if you look in the lower right hand corner there are some drop down options next to the datum info. Quote Link to comment
Charlie Winter Posted November 19, 2018 Author Share Posted November 19, 2018 Thanks, gents. I'm sure that I verified the data bar options were all set as you have described above, which is why I posted this in the first place... At the moment now I cannot reproduce the problem. I'll have to follow up on this post again if I encounter the problem once more. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.