Jump to content
David S

wonky roof

Recommended Posts

 

image.thumb.png.188e303abbc72ae5c828e78c1e3e974a.pngimage.thumb.png.b1c516cde4cc0c96162d8cee6aa74c59.png

 

See that? That's a wonky assymetric garage roof which bends down towards the rear (hopefully) The side wall is also sloped. I have managed to represent the wonky roof  using a modified 3d polygon but how do I/ can I now thicken this up to make it more representative of a (wonky) roof. As always in VW my motto is if the builder can do it so can I!! Any help gratefully received. (I am a novice at nurby things...)

Share this post


Link to post

I run into something similar a couple of weeks ago: hope this could be helpful for you as well!

 

Edited by STR
  • Like 1

Share this post


Link to post

image.thumb.png.dc056337f980aee6ff8aa8e137683eeb.pngimage.thumb.png.c95db799cea0701638d10e993f31525c.png

 

 

Thanks for replying @STR    ooh this was tricky! I didnt do it the same way but your response inspired me! I used the create roof tool to establish the geometry. Then I ungrouped the 3 roof faces. The one to the left was incorrect (it hovered above the wall below which I was expecting) so I recreated it and angled it differently by eye (I didnt know you could create a bi-angled roof this way before). I also had to do a bit or reshaping but I got it to work without doing some very complicated geometry! Good Stuff, thanks again!

  • Like 1

Share this post


Link to post

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×