Jump to content
  • 0

Update Service Pack


alfresco

Question

1 answer to this question

Recommended Posts

  • 0

When updating any software it must first be closed. It's kind of like changing a car wheel with a flat tyre; The car must be stationery and the wheel off the ground to swap it out. 

 

It sounds like you've already downloaded the SP1 updater (on Mac) in which case just: 

  • Quit Vectorworks
  • Double-click the updater and follow your nose. 

Note that an updater is distinct from an installer. If you've downloaded the SP1 installer it's not intended to be run 'over the top' of an existing installation of Vectorworks. You should always access your updaters from within Vectorworks. For Mac users go to the Vectorworks menu > 'Check for Updates' then follow through as above. 

Edited by Jeremy Best
clearer language used
  • Like 1
Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Answer this question...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...