Site model settings not working in 2d mode

[J. Wallace]

I created a site model in VW 2018 and for some reason, I'm not getting major contour lines in the model. I fill in the field for this and set it to 10', click ok and nothing happens.

I revisit the dialogue box and the major contour is set at 0.

Any ideas would be warmly received.

[Tony Kostreski]

Hey J Wallace, can you try inputting 10 without the foot (') sign. If you place the (') it will revert back to zero (0). Since it's a multiplier, the command is asking for however many minor contour intervals do you want a major contour interval (i.e. if you wanted every 5' contours and your minor is 1' then you would simply place 5). Hope this helps!

[J. Wallace]

Thanks very much @Tony Kostreski that was it...