J. Wallace Posted September 26, 2018 Share Posted September 26, 2018 I created a site model in VW 2018 and for some reason, I'm not getting major contour lines in the model. I fill in the field for this and set it to 10', click ok and nothing happens. I revisit the dialogue box and the major contour is set at 0. Any ideas would be warmly received. Quote Link to comment
Vectorworks, Inc Employee Tony Kostreski Posted September 26, 2018 Vectorworks, Inc Employee Share Posted September 26, 2018 Hey J Wallace, can you try inputting 10 without the foot (') sign. If you place the (') it will revert back to zero (0). Since it's a multiplier, the command is asking for however many minor contour intervals do you want a major contour interval (i.e. if you wanted every 5' contours and your minor is 1' then you would simply place 5). Hope this helps! 2 Quote Link to comment
J. Wallace Posted September 26, 2018 Author Share Posted September 26, 2018 Thanks very much @Tony Kostreski that was it... 1 Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.