2019 where I left off

[jnr]

Anyone else notice that a converted 2018 file reopens in the same location everytime? Open a file, change views (page, design layer- doesn't matter) save the file. Reopen and you're back to where you started when the file was converted. In otherwords while it saves the data of changes you made, its not saving where you left off when you closed the file. This is not normal. 

[ericjhberg]

If you make any changes to the document, do they save?

[jnr]

yes. changes save just fine. what doesn't change is the view where I left off. In this case say I go in and work on design layers save the work and close, then reopen the file and it puts me back where I started on a sheet layer view. It's a bug.

[Taproot]

2 hours ago, jnr said:

yes. changes save just fine. what doesn't change is the view where I left off. In this case say I go in and work on design layers save the work and close, then reopen the file and it puts me back where I started on a sheet layer view. It's a bug.

 

I can confirm this behavior as well.  It will save your view location on the sheet layer itself, but if you are on a design layer and save ... the next opening will bounce you to a sheet layer.

[Patrick Fritsch]

Dido, same here. Did any of you already file a bug submit?

[jnr]

have not, but then again bug submit is no longer obvious so can't figure out how to do that anymore.

[PVA - Admin]

Just now, jnr said:

have not, but then again bug submit is no longer obvious so can't figure out how to do that anymore.

https://www.vectorworks.net/support/bugsubmit

[Patrick Fritsch]

Jim W could you confirm this. Related to this bug I think. VW is not remembering settings like when i disable the cropped perspective view in document preferences and "save as" my file. 

[leecalisti]

Ditto same here