NicolaO Posted July 30, 2018 Share Posted July 30, 2018 I'm trying to put together a planting plan and am experiencing problems I haven't had before. When I import a plant from the resource browser it works absolutely fine. However, when I 'duplicate' a plant to make a new entry and then place it onto my design layer, the plant disappears and can't be selected or edited unless I close and reopen the program, or go to a sheet layer and then go back into the design layer again. Also for some reason, these plant entry symbols are appearing smaller than the ones which I have imported from the resource browser when I view them all in the resource browser and I wondered if this is also connected to the above problem? I'm sure the answer is obvious, but I don't know my way around VW very well! Many thanks. Quote Link to comment
Vectorworks, Inc Employee PVA - Admin Posted July 30, 2018 Vectorworks, Inc Employee Share Posted July 30, 2018 If you restart the machine, does it behave the same way after? If so, reply back with the following from that machine please: Quote Link to comment
NicolaO Posted July 30, 2018 Author Share Posted July 30, 2018 Hi Jim, Sadly restarting hasn't worked. iMac.spx Quote Link to comment
NicolaO Posted July 31, 2018 Author Share Posted July 31, 2018 Anyone have any further thoughts about this? Quote Link to comment
Vectorworks, Inc Employee Tamsin Slatter Posted August 11, 2018 Vectorworks, Inc Employee Share Posted August 11, 2018 Have you turned off the None class? This can cause Plants to become invisible, even if they are not members of the None class. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.