Jump to content
Chris Burk

Surface-Sliding Door

Recommended Posts

I did mine manually from Solids so far.

 

I just used an additional Door as "framed only" for the

frame and to cut the Wall.

Panel and tracks were Solids.

  • Like 1

Share this post


Link to post

Hi Chris, attach is a barn door done as Zoomer described, pay attention to the flip and offset for the door positioning

Also keep an eye on the Marionette forum in the next couple of weeks...

 

Barn_Doors_v2018b.vwx

  • Like 3

Share this post


Link to post

ahhh! I wish I had seen this 2 weeks ago! My solution was two parts, a Cased Opening Door with a Symbol of the track door that doesn't cut the wall. This is so much more elegant a solution.

  • Like 1

Share this post


Link to post
On 6/12/2018 at 5:23 PM, JuanCarlos said:

attach is a barn door

 

Nicely executed. Good share.

 

Thankyou

  • Like 1

Share this post


Link to post

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×
×
  • Create New...