Tiling oversized drawings to pring

[MHBrown 20]

Up to VW2016 I was able to print oversized drawings by tiling the output. I could print at 200 percent over four sheets of 11x17 paper. In VW2018 I cannot seem to do this. Even when I set it up the same way in the Page Set up it only prints to one 11x17 page (though it prints the four quadrants of that sheet in the manner of a tiled sheet: four separate mini-versions of what I'd like filling four separate 11x17 sheets.) Can someone explain what is up with this? I seem to remember a "tile drawing" option or something like that. Has that been removed?

MH Brown

[Gadzooks 108]

Hi @MHBrown

 

Does this help?

 

http://app-help.vectorworks.net/2018/eng/index.htm#t=VW2018_Guide%2FPrintPublish%2FPrinter_Setup.htm&rhsearch=printer setup&rhhlterm=printer setup&rhsyns=

 

 

[MHBrown 20]

To, Gadzooks,

Thank you, but that doesn't work either. I think something was changed in VW, the MacOS, or with the Xerox driver software that has broken the ability to tile VW drawings. This is an unfortunate event for me, limiting the size of my drawings to 11x17. I appreciate your advice, however.

 

MHBrown