Jump to content
assemblyarchitecture

Stair down label

Recommended Posts

Maybe the Select/Drag Tool Mode is currently set to most left "move only" mode

so that the handles wont appear ?

  • Like 1

Share this post


Link to post
22 hours ago, zoomer said:

Maybe the Select/Drag Tool Mode is currently set to most left "move only" mode

so that the handles wont appear ?

It sounds accurate

Use the center or right interactive mode in the tool bar, that should activate the blue handles 

Screen Shot 2018-05-22 at 3.51.17 PM.png

Share this post


Link to post

Deleted

Edited by Alan Woodwell

Share this post


Link to post

I think that the upper floor doesn't allow me to alter the label location, but I can change the location of the upper location on the lower floor (first image). There is that blue dot but not on the upper floor (second image). So I guess that's a solution in air quotes, but it seems odd to have to move a label on the lower floor but not be able to edit on the upper floor. There are also two ways to add a down or up arrow with the stair data tab which seems somewhat confusing. The run is adjustable but the note one is not as far as I can tell.

 

1517337024_lowerfloorupperlabeldot.thumb.png.fad4aa9625fd6cc6abfead43f6d7dca5.png

 

606985669_upperfloornodot.thumb.png.087c19f9637aacbb611ca27078309148.png627731726_stairdata.thumb.png.b3a04d9a6ac78dde1e783706e57580f4.png

 

 

Edited by assemblyarchitecture

Share this post


Link to post

You are right controlling the Upper Floor notes on the Lower Floor layer is odd, I just got used to it (not good), I will write an enhancement request 

There should be handles for each of the Runs and Notes, in your case I would think that they are stacked on top of each other 

BTW The Stair object does not play well with mirroring nor flip, use the radio buttons on the general panel of the Stair settings

HTH

Screen Shot 2018-05-23 at 4.04.47 PM.png

Screen Shot 2018-05-23 at 4.12.24 PM.png

Share this post


Link to post

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×
×
  • Create New...