Jump to content
Scott61

Pilaster height

Recommended Posts

Hi, I have been working with the pilaster tool, but cannot figure out how to adjust the height.  Vectorworks creates the pilaster at the wall height of the layer, but I need them taller.  "Z", I assume would take it off the floor, while the X and Y are it's placement within the drawing.  How can I make the pilaster taller?  Thanks!5ae22c0391fd6_ScreenShot2018-04-26at2_43_36PM.thumb.png.29f39931c548e6e72f3c967d39952b7f.png5ae22c1d87aa1_ScreenShot2018-04-26at2_44_19PM.thumb.png.a03ba4a21c27dc79de30e0069a313ea2.png

Share this post


Link to post

I think there's been a bit of an oversight here...if you change the "Use Component" drop-down to "Architectural and Structural", that will expose the " Arch Height" field you are looking for.  Once adjusted, you can then switch back to just Architectural.

Screen Shot 2018-04-26 at 4.58.16 PM.png

Share this post


Link to post

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×