Scott61 Posted April 26, 2018 Share Posted April 26, 2018 Hi, I have been working with the pilaster tool, but cannot figure out how to adjust the height. Vectorworks creates the pilaster at the wall height of the layer, but I need them taller. "Z", I assume would take it off the floor, while the X and Y are it's placement within the drawing. How can I make the pilaster taller? Thanks! Quote Link to comment
Guest Wes Gardner Posted April 26, 2018 Share Posted April 26, 2018 I think there's been a bit of an oversight here...if you change the "Use Component" drop-down to "Architectural and Structural", that will expose the " Arch Height" field you are looking for. Once adjusted, you can then switch back to just Architectural. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.