Jump to content
Endre Torkildsen

Mirror / copy tools, braceworks load ID

Recommended Posts

I often have a setup that will be quite the same on the other side of the centre point. Therefore I often want to use the mirror or copy tool. 

I cant say that this always happens but I often have a problem with objects that have been "mirror/copied" do not have a new Load ID. It still keep the same load ID as the symbol that it was "mirrored / copy" from.

Is it a fix for this? 
I have attached a picture that shows an example of what I mean. At this project, it is a 360 degrees screen, and when I have drawn all of the projection of the one side it would been nice to mirror it to the other side. When I do the Mirror function I need to adjust all of the "load ID" on the items I mirrored. 

 

Yes, it is not a very big issue, but it takes a bit of time to do that to very time you mirror or copy symbols that need to be a part of the braceworks calculation. 
 

Skjermbilde 2018-03-16 kl. 00.59.53.png

Share this post


Link to post

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×