roza Posted January 22, 2018 Share Posted January 22, 2018 Hi all, I did create a roof but when I view 'left isometric' or 'front' etc. roof is not on the top of the wall. How I can correct? Thank you Quote Link to comment
CipesDesign Posted January 22, 2018 Share Posted January 22, 2018 Move it up or down using the Move 3d command. When you create a Roof make sure to set the Bearing Height to the correct value. I usually set up my Design Layers so that the Floor Plan (where the Walls are) and the Roof layers have the same Z (elevation) value. Then when I create a Roof there is no additional math to do [eg: if walls are 8 ft high, then Roof will bear at 8 ft]. Quote Link to comment
roza Posted January 23, 2018 Author Share Posted January 23, 2018 @CipesDesignThank you. Since I am beginner its very hard Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.