Jump to content

Roof 3D view


Recommended Posts

Move it up or down using the Move 3d command. When you create a Roof make sure to set the Bearing Height to the correct value. I usually set up my Design Layers so that the Floor Plan (where the Walls are) and the Roof layers have the same Z (elevation) value. Then when I create a Roof there is no additional math to do [eg: if walls are 8 ft high, then Roof will bear at 8 ft].

Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...