Bruce Kieffer Posted December 10, 2017 Share Posted December 10, 2017 I have to work in both MM and inches at the same time. It would be very helpful if the OIP had an option to show dual dimensions. Quote Link to comment
0 J. Wallace Posted December 11, 2017 Share Posted December 11, 2017 Totally agree, I often need to flip between feet/inches and meters. Anything to improve this would be great. Quote Link to comment
0 Jim Smith Posted December 13, 2017 Share Posted December 13, 2017 I'm sure you know you just have to type say 5/8" in the value & you get a hard conversion to mm. I have an custom dimension that's a Architectural Stacked Dual dimension that works for when I have a client or contractor that needs imperial. I tend to think that showing both might be too confusing especially on PIO's that have a pretty dense set of parameters already. Quote Link to comment
0 Bruce Kieffer Posted December 14, 2017 Author Share Posted December 14, 2017 I too have a dual dimension standard, but I use that only because the OIP does not show me both " and mm. Quote Link to comment
Question
Bruce Kieffer
I have to work in both MM and inches at the same time. It would be very helpful if the OIP had an option to show dual dimensions.
Link to comment
3 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.