Jump to content

Hello Community!

This Thursday, October 21st, from 6 pm to 7 pm EDT, we will be performing an update on the Vectorworks Community Board. During this time, the site will be unavailable.

Subdivide a Subdivision?


Alt+F4

Recommended Posts

If you mean dividing a subdivision surface are into smaller areas, then yes that is possible.


The Edit subdivision tool has the add edge and remove edge modes to further divide a surface into smaller areas by using the add edge tool. This may alter the geometry in some unexpected ways when you further edit it. Remove edge can also alter the geometry. As long as you do not change the geometry inbetween add edges then remove edge will bring you back to the previous state when you remove added edges in the same order.

 

Add edge divides an edge into two part, after which you can use remove edge to remove on of these parts and make two touching subdivision areas become one subdivision area.

 

There is also the split mode to further divide subdivision surfaces.

 

It will take some trial and error to figure out how things work out with this tool when it comes to your geometry.

Edited by Art V
Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...