I'm finding that I can't get the "set working plane" tool to find faces that are within symbols.
I don't think this was a problem in 2017.
Attached is a screen recording. I've simply got two extrudes but one is within a symbol. You can see that while the SWP tool finds faces on the "normal" extrude without any problem, behaviour on the one within the symbol is erratic. It seems to be able to find faces when I hover near the bottom, but further up it sometimes does and sometimes doesn't. And it can't find the top face at all.
(NB this is whilst outside of the symbol. If I double click to go into and edit the 3d symbol, then it works fine)
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
line-weight
I'm finding that I can't get the "set working plane" tool to find faces that are within symbols.
I don't think this was a problem in 2017.
Attached is a screen recording. I've simply got two extrudes but one is within a symbol. You can see that while the SWP tool finds faces on the "normal" extrude without any problem, behaviour on the one within the symbol is erratic. It seems to be able to find faces when I hover near the bottom, but further up it sometimes does and sometimes doesn't. And it can't find the top face at all.
(NB this is whilst outside of the symbol. If I double click to go into and edit the 3d symbol, then it works fine)
symbolwp.mov
Edited by line-weightLink to comment
6 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.