wprescott 6 Posted September 21, 2017 I am having an issue getting things like Speaker Arrays, or projectors/Screens to attach to truss to be included in the weight calculations ANyone have a solution? Quote Share this post Link to post
0 Rob Books 189 Posted September 21, 2017 I know probably silly question, but did you turn your truss into a hang position? they should connect after it is converted. Quote Share this post Link to post
0 wprescott 6 Posted September 21, 2017 so when you use the truss insertion tool i don't believe you have to. attaching lighting is fine its other things like speakers and screens. but to answer your actual question, yes i have tried that but these things still dont attach properly to the truss. ALSO, when i want to do arrays off a single point and there is no truss required, how do you get that to attach to each other. i have tried converting the arrays to truss but still no luck the only work around i have found is to not include these items in the calculations and then inserting a load point on the truss where my speakers, screens, projectors, etc. are 1 Quote Share this post Link to post
0 Wesley Burrows 100 Posted October 25, 2017 On 9/21/2017 at 1:01 PM, Rob Books said: I know probably silly question, but did you turn your truss into a hang position? they should connect after it is converted. I have done this and drawn things on a hanging position and they don't auto-attach. I have to right click and manually attach everything other than lights. (most of the time, some times lights too) Quote Share this post Link to post
0 Wesley Burrows 100 Posted October 25, 2017 On 9/21/2017 at 1:28 PM, wprescott said: so when you use the truss insertion tool i don't believe you have to. attaching lighting is fine its other things like speakers and screens. but to answer your actual question, yes i have tried that but these things still dont attach properly to the truss. ALSO, when i want to do arrays off a single point and there is no truss required, how do you get that to attach to each other. i have tried converting the arrays to truss but still no luck the only work around i have found is to not include these items in the calculations and then inserting a load point on the truss where my speakers, screens, projectors, etc. are I have the same issue. 2018 SP1. Quote Share this post Link to post
I am having an issue getting things like Speaker Arrays, or projectors/Screens to attach to truss to be included in the weight calculations
ANyone have a solution?
Share this post
Link to post