Kaare Baekgaard Posted September 20, 2017 Share Posted September 20, 2017 (edited) Where did my bottom, back and right isometric views go? Am I the only one, who gets greyed-out views? – see the attached pic. As a general purpose user, I do use them sometimes, so I hope, it is a temporary flaw. Edited September 20, 2017 by Kaare Baekgaard miswrote Quote Link to comment
Gadzooks Posted September 21, 2017 Share Posted September 21, 2017 This sudden? Could you confirm which VW you are using please. (Would be helpful if you used a signature with this information in) Quote Link to comment
Gadzooks Posted September 21, 2017 Share Posted September 21, 2017 Ok - (should have looked a little closer) Just seen you have multipane available in the dropdown - so you are on 2018 Quote Link to comment
Vectorworks, Inc Employee PVA - Admin Posted September 21, 2017 Vectorworks, Inc Employee Share Posted September 21, 2017 This looks like a customized workspace, as those items are normally in View > Standard Views. I recommend removing the items or item set via the workspace editor and then re-adding them. Quote Link to comment
Gadzooks Posted September 21, 2017 Share Posted September 21, 2017 4 minutes ago, JimW said: This looks like a customized workspace, as those items are normally in View > Standard Views. I recommend removing the items or item set via the workspace editor and then re-adding them. Haha - Just getting there myself Quote Link to comment
Kaare Baekgaard Posted December 14, 2017 Author Share Posted December 14, 2017 Thanks, Jim Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.