shasta Posted January 21, 2003 Share Posted January 21, 2003 I've made a DTM that seems to be working well of a sloping site. What I need to do is make a large pad 'held-up' by 2 low walls below (holding-in the fill)and backed by 2 low walls above (holding back the cut)[by the way, I need 2 walls to keep their heights below 4']. I've managed to make a pad at the right elevation that has steeply sloping sides. What I need to do is replace the sloping sides with abrupt walls. Here's what I'm thinking so far: I make the top of the inner, lower wall the height of the pad and the bottom of the wall sloping from [the lowest point]-[wall height] of the original terrain up to the highest]-[wall height]and now I'm confused again!! Anyone done this kind of thing? Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.