Chris Burk Posted August 4, 2017 Share Posted August 4, 2017 I can't seem to get my walls to show in elevation at the different elevations. I have a floor that has a section at one side that is 4' below the other side. I have used the wall offset top and bottom, but it doesn't seem to affect my elevations. Quote Link to comment
Jonathan Pickup Posted August 4, 2017 Share Posted August 4, 2017 are you trying to have the components on one side different to the other side? maybe a sketch would help to see what you want. Quote Link to comment
Chris Burk Posted August 6, 2017 Author Share Posted August 6, 2017 (edited) Yes, the upper portion above the pipe chase is 4' higher than the lower portion, including the Lobby. A101.pdf elevations are not drawn correctly. The left side should be 4' higher than the right side. A201.pdf Edited August 6, 2017 by Chris Burk Needed to add an additional elevation for clarification Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.