Jump to content
  • 0

Unified View display?



I have a project with three floor levels. The Story elevations are set up (LL=-8’-8 ¼”, 1st Flr=0’0”, 2nd Flr=9’1 ¾”), w/ Design Layers set the same. When I invoke the Unified View in Top/Plan, all of the plans show up. When I change to 3D (say left isometric) only the active design layer switches to 3D. If I change the other layers to 3D they all show with the same bottom elevation, not stacked as they should be. What am I doing wrong?

Link to comment

2 answers to this question

Recommended Posts

  • 0
  • Vectorworks, Inc Employee

If all of your layers don't move into a 3D view at the same time, Unified View is disabled. Under View > is "Unified View" checked or unchecked? What options do you have set in Unified View Options?

Keep in mind that if you had saved views and are toggling through them, Unified View can be turned on and off automatically by these.

Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Answer this question...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...