1. Create a default wall insertion mode that only allows angles that are multiples of the document snap angles. If the user attempts to turn the mode off, throw up a warning similar to the new warning the users sees when disabling interactive scaling mode.
2. Same for roof axis line on roof face objects. Make the user aware before accepting a roof axis line that is 89.97º!
3. Report (and make editable?) the angle of the roof axis line in the OIP for the roof face object.
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
michaelk
3 Requests:
1. Create a default wall insertion mode that only allows angles that are multiples of the document snap angles. If the user attempts to turn the mode off, throw up a warning similar to the new warning the users sees when disabling interactive scaling mode.
2. Same for roof axis line on roof face objects. Make the user aware before accepting a roof axis line that is 89.97º!
3. Report (and make editable?) the angle of the roof axis line in the OIP for the roof face object.
Link to comment
0 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.