Jump to content

3D Objects on Plan View


Recommended Posts

I often have to indicate a cupboard above on a furniture plan. I have to group this as a hybrid 2D dotted line in a class A-Millwork Above and a 3D object that represents a cabinet in an elevation & or a section. I'm not interested in getting into the weeds designing the cupboards, just showing the intent in 2D & 3D. This is a pain as one has to remember to adjust in both classes when a things change.   Is there an alternative?

Link to comment

@Jim SmithHi, You may be already doing it this way but i handle this situation as attached. 3 classes for the Hybrid and saved as a style so anytime i create a hybrid it sets up automatically, then its just a matter of adjusting the heights as needed. High stuff I leave the cut plane set to zero while anthing i need to look down on i set it at a height above the height of the top relative to the design layer RL.

PS After you first set up the Hybrid click this bottom save asCapture.JPG.f5c8635dcdcfa0e773b2e8d9e1e90d2d.JPG (attached) and all will set up automatically for the hybrid.

 

Capture.JPG

Cupds.vwx

Edited by Alan Woodwell
Link to comment

I wouldn't want to show the ridges & valleys of on a floor plan. Conventionally one would show a dashed line to represent the line of the roof above at the roof's edge. Your illustration is good as it makes me realize there should be a Class to a Roof object to allow one to do this.

Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...