Filled Door Headers in RCP

[JHAM]

Hello all,

 

I've searched the forum, but haven't found a solution for my specific problem. I've created an RCP with the floor layer on top, and ceiling layer below. I would like the door headers to have a solid fill, so that they obscure the modeled ceiling structure. I've turned on Ceiling-Main class, but the Wall Lines that appear are only lines, they don't contain a fill. So my ceiling structure is showing up where the door header should be.

 

I've tried creating a new Door-Threshold class with the settings I would like to see, but I can't figure out what the Door Style 2D visualization settings for the Threshold controls.

 

Attached are my Door 2d Visualization settings and a screen shot of the RCP.

I'm using VWX 2017, SP-3.

 

Any ideas?

Thanks,

Jena

 

also, don't ask me where the room labels are.  they've disappeared, yet again.

[cberg]

As far as I can see filled headers are not possible.  Can we move this topic to the wish list.  I wind up placing rectangles over them on a class I can turn off.  A decidedly non-BIM approach.  :-)

Edited October 31, 2017 by cberg