Jump to content
  • 0

Not displaying changes


AllenM

Question

I wanted to ask if anyone has had any trouble with vectorworks 2017 not displaying a change to their geometry

instantly once it is done.  For example filleting 2 lines together after you pick each line and it does not change

until you roll your mouse wheel or change the zoom.

I have 16gb ram, 4gb video ram on separate video card, brand new 7200 rpm hard drive on a i7 motherboard,

Windows 7.

Anyone having this issue?

Edited by AllenM
wanted to add my system configuration
Link to comment

5 answers to this question

Recommended Posts

  • 0
  • Vectorworks, Inc Employee

Disconnect (unplug the video cable, not just turning it off) all but one of the monitors from this machine, reboot, and then in Vectorworks retry the zoom/pan test. Tell me if the same behavior occurs.

If it does, it is also worth downloading and installing this (make sure you select Clean Installation when prompted by the installer) with Vectorworks closed and then trying again as well:

 

http://www.geforce.com/drivers/results/115886

Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Answer this question...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...