Line end marker too large on sheet layer

[kufuffin 4]

I'd like to use line end markers in the design layer, but they always appear way over-sized on the sheet layer.  Can someone advise me as to how to achieve this functionality?  Thank you

[bcd 295]

There is a setting in the Viewport's OIP that handles this situation: OIP>Advanced Properties>Marker Scaling>Custom

[J. Wallace 71]

I usually add call-outs (other than plant labels) in the annotation section of the viewport. Scaling is then no issue.

[Christian Fekete 17]

my question is how do you keep an end marker type you create in previous drawing, maybe create a new standard

[Boh 460]

On 2/17/2017 at 10:08 AM, kufuffin said:

 

I'd like to use line end markers in the design layer, but they always appear way over-sized on the sheet layer.  Can someone advise me as to how to achieve this functionality?  Thank you

 

If you want to put annotations on the design layer I think best Practice is to do this only for your main plans which are all at a common scale of say 1:50. To have your page based markers, text, line types etc all look the same in both the DL and the viewport you need to set the DL scale the same as the VP scale. So if your main vps are 1:50 set your DL scale to 1:50.

 

I tend to only put annotations on DLs that I want to be seen in more than one VP. Room names are a good example. Annotations that only need to be seen in one VP I put in that VP’s annotations.