I'm experiencing issues with the hole pattern tool.
It works fine when your hole type is set to "round", but when you go to "slotted horizontal", you're unable to change the slot width... Slot length is fine, but slot width just throws out your changes.
Only way to put in a value is to change the hole type to round, put in a new diameter and then change back to "slotted horizontal". Bit annoying as it slows you down quite a lot.
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
RussU
Hi everyone.
I'm experiencing issues with the hole pattern tool.
It works fine when your hole type is set to "round", but when you go to "slotted horizontal", you're unable to change the slot width... Slot length is fine, but slot width just throws out your changes.
Only way to put in a value is to change the hole type to round, put in a new diameter and then change back to "slotted horizontal". Bit annoying as it slows you down quite a lot.
VW 2017 Designer, SP2
Win 8.1
Link to comment
3 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.