Jump to content

Printing


Recommended Posts

1. Shouldn't the 'Printing' forum be updated? There's no mention of VW 9.x.x not being approved for use on MacOS X.3 (it's not NNA's fault, but a warning would be nice), or of VW 9 (maybe 10 also) not wanting to plot (or print?) at a scale of less than 25% or greater than 400% (these limits were in place for VW8.x.x under MacOS 9).

2. I have a drawing that won't plot under certain conditions. It is a LARGE floor plan, but not yet a very large file (2-3MB give or take). Page setup to 24"x36", plotting at <100% prints a blank 24x36. Plotting at 100% plots just fine. Changing the drawing's scale to fit on the 24"x36" sheet, then plotting at 100%, also works fine.

Here's the print flow:

Client [MacOSX.2.6, VW9.5.3] prints to shared print queue, on

Print host [MacOSX.2.6, no VW] sends to plotter connected to

RIP machine [MacOS9.2.1, no VW, HP RIP software] and sends to

HP DesignJet 500PS Plotter

Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...