Jump to content
  • 0
Sign in to follow this  
kufuffin

Site model contours at stairs

Question

Attached is an image of a staircase with landings and a retaining wall on one side.  The lower staircase was easy, just 2 sloping contours and the adjacent pads.  The upper part required a lot more work because of the landings and the sloping terrain adjacent.  Could these sloping contours be automatically generated as a feature added to the stairs?  

 

Alternatively, could you give the contour the operability  of the 3D polygon so i can snap it to the edges of the stairs with the correct Z height (ie not have to set z height in the OIP)?

 

Screen Shot 2016-12-14 at 9.16.39 AM.png

Screen_Shot_2016-12-14_at_9_21.50_AM.png

Share this post


Link to post

1 answer to this question

Recommended Posts

  • 0

You could use the 3D Polygon tool to draw 3D Lines directly onto you stair edges.

3D Move them down a bit and add them to your proposed models geometry.

Maybe add some grade limits to control the line flow.

Or add any 3D Loci to force corrections in special details. 

  • Like 1

Share this post


Link to post

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×