Jump to content

Old dog switching from VW 12 to 2013 - Trimming lines also affects adjacent rectangles

Recommended Posts

When I draw in 2d and build up my sections - I often cut through lines by drawing a line, trim what it crosses, then delete the line.  Those trim lines often run alongside rectangles I draw that are things like plates and joists.  In vw13 when I perform the trim - it converts the rectangle into a ployline and removes the side of the rectangle the trim line runs along.  IS there a setting or something I am missing that I can set to not affect the rectangles?  Screen shot attached

Screen Shot 2016-11-28 at 3.43.16 PM.jpg

Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...