bc Posted September 25, 2003 Share Posted September 25, 2003 I am new to VW 10.5 and want to combine a floorplan in one document with a siteplan in another document. How do I combine the two ? Or is this not possible?Anyone? Quote Link to comment
P Retondo Posted September 25, 2003 Share Posted September 25, 2003 bc, what do you mean by "combine?" What you want to do can most likely be done, but I can't tell what you're trying for. Quote Link to comment
bc Posted September 25, 2003 Author Share Posted September 25, 2003 Thanks for your reply. What I want to do is place a floorplan from one file onto a site plan which is in a different file. This would seem to be basic at most but such is the extent of my experience. Thanks again. Quote Link to comment
jnr Posted September 25, 2003 Share Posted September 25, 2003 Actually, use the workgroup reference tool and reference the floor plan layer into the site plan. You may have to adjust the saved sheet in the site file for classes (so that only the info you want appears). For site plans, this usually means turning a lot of stuff off so that you get just the buildng outline. Also make sure to look at the document preferences and the hide wall cavities check box if you need to turn off the wall cavities because the scale of the site plan is too small. Good Luck. Quote Link to comment
bc Posted September 25, 2003 Author Share Posted September 25, 2003 Thanks everyone Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.