I have just used two days to model a chair using subdivisions.
The improvements in VW 2017 are massive.
As one of the few remaining general purpose users of VW, I often feel snubbed by new releases, since many basic drawing tools have not been improved in more than a decade.
But with this release, subdivision has become truly workable
It is great, that I can change meshes into subdivisions.
I wish, I could go the opposite way as well:
By clicking in the OIP, I would like to be able to change the viewing mode of any subdivision, so that I would only see the cage.
Then, if I changed it into a mesh, I would only get the geometry of that cage.
Ideally I would then be able to go back and forth between mesh and subdivision in order to refine the design.
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
Kaare Baekgaard
I have just used two days to model a chair using subdivisions.
The improvements in VW 2017 are massive.
As one of the few remaining general purpose users of VW, I often feel snubbed by new releases, since many basic drawing tools have not been improved in more than a decade.
But with this release, subdivision has become truly workable
It is great, that I can change meshes into subdivisions.
I wish, I could go the opposite way as well:
By clicking in the OIP, I would like to be able to change the viewing mode of any subdivision, so that I would only see the cage.
Then, if I changed it into a mesh, I would only get the geometry of that cage.
Ideally I would then be able to go back and forth between mesh and subdivision in order to refine the design.
So the question is: Can I get that?
Link to comment
12 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.