ericjhberg Posted September 15, 2016 Share Posted September 15, 2016 It is early yet and I am still fiddling with the irrigation tools, but so far...awesome! I did run into one snag. When setting up a drip zone and using a drip control kit with a pressure reducing filter, the calculations for the zone don't seem to account for pressure regulation, just pressure reduction. For example, traditionally my input pressure is 65 psi, but the zone kit would reduce that to an output pressure of 40 psi, no matter the input. In the software, it seems to work that the input pressure gets reduced by 40psi, leaving an output pressure of 25 psi in this example. Not what you want to ensure your calcs come out right. Any ideas? Quote Link to comment
ericjhberg Posted September 15, 2016 Author Share Posted September 15, 2016 Also, can you use a hatch for drip zone outlet devices instead of it showing the pipe? At smaller scales, the piping won't read at 18" or 12" on center, so we need diagrammatic control! 1 Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.