Kevin Posted June 17, 2002 Share Posted June 17, 2002 Robert:Thank you for your quick reply. The "Snap to Loci" was not originally checked. After your suggestion I checked it to make it active and there was no change. I then un-checked it to make it inactive again and once again, no change. Any more ideas? Quote Link to comment
Kevin Posted June 18, 2002 Author Share Posted June 18, 2002 I am using VW8.5.2 Architect on OS9.2. I used the Grid Method Entry to input the elevation data. When I view the 3d mesh, there are multiple lines that extend to infinity below my mesh model. In a side view, there is the model and then these vertical lines that run down to infinity off of the screen. I went back and checked the elevations of the loci to see if there were any negative numbers but all the data seems to be in order. The model is a relatively flat site with elevation data ranging from 7 feet to 12 feet. Any ideas on what is wrong? Quote Link to comment
Vectorworks, Inc Employee Robert Anderson Posted June 18, 2002 Vectorworks, Inc Employee Share Posted June 18, 2002 Turn off "snap to loci" in your preferences. Just a guess. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.