AlanW Posted August 22, 2016 Share Posted August 22, 2016 (edited) Hi, For those who have issues with the fact that the nodes are so small when you run and create an object you can see both in one drawing graphically the same. Attached file has the network on Design Layer 1 at Scale 1:1. Drawing is produced on Design Layer 2 at Scale 1:10 So with unified view turned off you see both, in top/plan see both, in top view you only see one layer at a time. This may help some to use Marionette. HTH If you don't see all your Design Layers in the OIP you set the design layer to active that doesn't show in OIP and open close and run and the new design layer shows. (Will be sorted out in next issue as I understand) Edited August 22, 2016 by Alan Woodwell Quote Link to comment
the frog Posted August 22, 2016 Share Posted August 22, 2016 No reason not to use the simplest vw solutions just because we are playing with Marionette. Thanks for sharing Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.