Jump to content

roof layer elevation not linng up


Recommended Posts

I am creating my roof and when looking at it in a front view, it doesn't sit at the correct elevation- It is a lot higher- What went wrong?

I set my my first floor elevation at 0 with an 8'-1" wall height- Then I set my roof layer at 8'1"=

However something is wrong because it does not sit at 8'1" elevation-

Ant suggestions

Link to comment
  • 4 years later...

Had something similar happen. What I found in my situation is that when you create a roof, even though you created it on the roof layer, it is automatically placed on the floor layout level. All you have to do is reposition it by dragging it up and into place. Does not change any other settings or elevations - they all stay correct. 

Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...