Jump to content
  • 16
Kevin McAllister

Snaps and Clip Cube

Question

11 answers to this question

Recommended Posts

  • 0

i would like this too, so that the face of the clip cube works like a working plane and you can snap to the point where the clip cube cuts the model

Share this post


Link to post
  • 0

Maybe even some Clip Cube lock, that I don't always accidentally grab the Clip Cubes Sides
while working with Objects.
And vice versa a Clip Cube Edit Only Mode to grab only its faces but no Objects,
with optional snapping deactivation ?
Maybe an option to show all Objects over standing the Clip Cube completly,
like they blinking appear when Selection Tool hovers anyway.

Share this post


Link to post
  • 0

The clip cube is very useful for examining sections.

 

However, I often want to check a dimension... let's say for example the headroom under a flight of stairs at a particular point, like either of A or B in the attached diagram.

 

Unless I'm missing something it's not possible to get the tape measure tool to snap to points or lines that are on the section cut plane.

 

This is very frustrating because the information is all there, it's just not possible to extract it easily.

 

The only way to do it accurately seems to be to make a section viewport, and then measure the dimensions by going into annotation mode.

 

 

Screen Shot 2017-01-19 at 10.49.22.jpg

Edited by line-weight

Share this post


Link to post
  • 0
5 minutes ago, Kevin McAllister said:

@JimW do you have the ability to combine threads? I believe this is the same as my earlier wish - 

KM

Aha, yes, I didn't see that thread.

Share this post


Link to post
  • 0

Just looking up this exact issue, so annoying! Come on Vectorworks - Pleeeeease sort it out.

Share this post


Link to post

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Answer this question...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×
×
  • Create New...