AlanW Posted December 22, 2015 Share Posted December 22, 2015 Hi, using the sweep node there doesn't appear to be a place to set up the sweep centre point.In VW you place a 2D loci as the centre, should this be placed in the node??? as at present I can only sweep around the edge of the polyline, and as long as its drawn the correct way it will sweep correctly otherwise it will sweep inside out. Thanks Quote Link to comment
AlanW Posted December 25, 2015 Author Share Posted December 25, 2015 (edited) So I sorted it, see attached. Placed a node and used a pass node to join them in one operation and then I could adjust the centre of the sweep. I am sure this is all simple to many people but to date I don't see a lot of tutorials out there so please bear with me and my NOOB questions. Edited December 25, 2015 by Alan Woodwell Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.