Jump to content

Taper top of cylinder


Recommended Posts

I can't figure out how to taper (angle) the top of a cylinder. Hopefully someone can help me out?

I started with a circle and then extruded it.

I then tapered it slightly so bottom surface is slightly smaller in diameter than the top surface.

All good so far...

But this is where it goes wrong..

I now need to angle the top surface at about 20 degrees leaving the rest of the object without any further deformation. (so if viewed from the side it would look like a wedge).

I have tried the Taper and Deform tool but I can't seem to make them work.

Is my approach to making this simple shape wrong?

Am I missing something obvious? :-)

Any help would be appreciated.

Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...