P Retondo Posted February 6, 2003 Share Posted February 6, 2003 I experienced joining two walls where the join was not performed. The wall that should have been extended to a "T" join in "capped join" mode remained the same length on screen, but the info palette and its handles show it to be the correct length. If I use the "remove wall breaks" tool, the extended wall appears at it should had the original join gone correctly. This glitch apparently has to do with an adjacent wall not involved in the join, which overlaps the wall to be extended. Once I clear the other wall away, the join proceeds correctly. I can send you a file which exhibits this bug. Quote Link to comment
Guest Posted February 6, 2003 Share Posted February 6, 2003 Try turning off Enabled Connect Wall Join Mode (last mode in the 2d selection tool Mode Bar), before joining the wall. Quote Link to comment
P Retondo Posted February 7, 2003 Author Share Posted February 7, 2003 Hi Katie, tried that, it still fails to join. Quote Link to comment
Guest Posted February 7, 2003 Share Posted February 7, 2003 Email one of the files to me, just to make sure I understand what you are saying correctly. Quote Link to comment
P Retondo Posted February 7, 2003 Author Share Posted February 7, 2003 Katie, I sent you a file. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.