smart cursor points not acquired in SP2

[Horst M.]

Oh My ?.

Its really hard with 2014.

Since updating to SP2 the Smart Points don't acquire anymore.

I tried everything?

Even with new Files and just lines and Sqaures no chance

I hope its just me being too stupid to set that right.

[PVA - Admin]

Mine all seem to be functioning properly after the sp2 update here.

Perform the following steps to backup and reset your Vectorworks preferences, then relaunch the application and see if the same problem occurs:

http://kbase.vectorworks.net/questions/1099/Resetting+Vectorworks+Preferences

[Horst M.]

Thanks Jim It worked.

But Ups:

It was a bit of a task, to find the Serial#?.

SInce it is not on the DVD anymore. :-)

And:

Is there a way to avoid loosing all the Workspace editing that one did, and

the List of Favorite Files in the Resource Browser while Resetting odd behavior

of VW.

or do i have to make a List of Notes about the changes that I make

Regards, Horst

[PVA - Admin]

You can attempt closing Vectorworks, then replacing the modified workspace and see if the problem is still resolved.

Normally the problem is not specific to the customized workspace. But if it is and you see the same problem after reverting back to your custom workspace, then yes unfortunately the changes would have to be made to a new workspace all over again.