Jump to content
  • 0

Garage door doesn't follow protocol

Tom G.


When I insert a door which I intend to next change to a garage door, I always pull the door swing into the garage as 99.9% of garage (roll-up) doors operate this way.

Why then does the garage door outline spring to the outside or exterior of the structure when a door is inserted? This goes back years.

There must be a reason or how could this behavior have gone on so long without a change?

How about rewriting this so the garage door outline springs to the interior of the building when a user pulls the door inward during insertion?

Make them match.


Edited by Tom G.
Link to comment

1 answer to this question

Recommended Posts

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Answer this question...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...