jmartinarch Posted May 17, 2013 Share Posted May 17, 2013 Okay, so what is the secret to inserting a door in the center of a wall. Should I measure the wall, draw a construction (temp) line, offset to center? I have snap to object on but the only snap hints that show up is 'along line' Is it possible to snap to mid point of a wall? Quote Link to comment
Guest Wes Gardner Posted May 17, 2013 Share Posted May 17, 2013 I typically run snaps as shown in the included image. This tends to give me about every conceivable snap I need including some of the not-so-obvious ones, for example, where you can hover over the endpoint until you acquire a small red square then go to another snap point, hover a second, then you'll be able to "get" the center point. It's very customizable and very complete...to temporarily suspend snapping, hold down the tilde key A quick way to get to the custom controls is to double-click on the snap-to-object icon where you'll get a dialog box that'll steer you in the right direction Quote Link to comment
jmartinarch Posted May 17, 2013 Author Share Posted May 17, 2013 It is working now. I think was temp. confused as to which was on or off the dark or light button. Thanks, have a good weekend. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.