Cadplan Architecture Posted May 12, 2013 Share Posted May 12, 2013 I posted this in the general discussions but it's probably better here as no replies there so far!- I'm using the stair tool in VWD2011, I want the 6 winders to taper down to 50mm so that they comply to English building regs, but I don't see anywhere to dial this measurement in. One screenshot shows 2D stairs which I want to create in 3D, the other shot shows the closest I have got there. The gap between the two flights needs to be around 100mm as it would be a wall. Any ideas how to sort this anyone? Thanks AJ Quote Link to comment
Joe-SA Posted May 13, 2013 Share Posted May 13, 2013 Try it with two 90 degree winders at the corners. You might even put in a single riser straight flight between them if just the two winders don't work. Joe Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.