Door openings have an option to show as Opening. In this condition, the hole shows the wall edge opened--there is no line from one side of the wall, through the hole, to the other side. In Plan View this is unnatural and causes one to have to hand-draw lines to cap the opening.
I could show a liner set to 1/16" to simulate what I really want, but that doesn't get to my point. Can't/shouldn't an opening set to Opening show a line capping the end walls at the sides of the opening?
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
Tom G.
Door openings have an option to show as Opening. In this condition, the hole shows the wall edge opened--there is no line from one side of the wall, through the hole, to the other side. In Plan View this is unnatural and causes one to have to hand-draw lines to cap the opening.
I could show a liner set to 1/16" to simulate what I really want, but that doesn't get to my point. Can't/shouldn't an opening set to Opening show a line capping the end walls at the sides of the opening?
Tom
Link to comment
1 answer to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.