Jump to content
  • 0

Openings should show wrapped

Tom G.


Door openings have an option to show as Opening. In this condition, the hole shows the wall edge opened--there is no line from one side of the wall, through the hole, to the other side. In Plan View this is unnatural and causes one to have to hand-draw lines to cap the opening.

I could show a liner set to 1/16" to simulate what I really want, but that doesn't get to my point. Can't/shouldn't an opening set to Opening show a line capping the end walls at the sides of the opening?


Link to comment

1 answer to this question

Recommended Posts

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Answer this question...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...