I wish that the new 2D graphic export in the DXF/DWG export dialogue box maintained the arcs and didn't turn them into lots of straight lines.
I also wish for the export to create one continuous polyline so the file could be used for laser/water cutting without a lot of further work in the CADCAM software.
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
GWS
I wish that the new 2D graphic export in the DXF/DWG export dialogue box maintained the arcs and didn't turn them into lots of straight lines.
I also wish for the export to create one continuous polyline so the file could be used for laser/water cutting without a lot of further work in the CADCAM software.
Link to comment
0 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.